Bearing and Hub assembly :: Assembly

Bearing and Hub assembly

Quality-Built® - Wheel Bearing

Over the last 10 years technology has struck in ever facet of our world from computers to electronic paper towel dispensers in the restrooms. I say give me back the lever, two pushes and I have enough paper. And I cannot stand the horizontal blow dryers.

In effort to speed up assembly in the automotive world, they designed front hubs that are unitized for quick assembly. Lucky people who buy a new car may never really feel the pain of a front hub failure on their car. For some reason though, I have bad luck with right-side hubs failing. Not really the hub failing, but the wheel bearing, and normally it shows up as a ABS light indicator. I have had five such failures.

In the past when a wheel bearing was making a noise is was simple to replace the $20 wheel bearings on a Saturday morning. It’s not quite so simple today, as we have traded quick assembly for easy wham, bam, done wheel bearing adjustments. Today the average price of a hub on a car is close to $300 and it’s a nightmare to change. No more Saturday morning, but rather all-day Saturday providing you have the right tools. So it’sback to the dealer, and two front hubs on a car are close to $1, 200.

Unitized hubs have now made the transition to our worlds of trucks for all of the same reason as above. They tend to last longer in miles because the bearings are larger and carry heavier load, but when we have one that fails the hub assembly is expensive.

A good friend and a peer of mine talk every Sunday morning about maintenance issues as a way of communication and challenging each other with issues of the week. Front hubs became a huge topic of discussion because he recently experience two failures with no warning and I have had some unitized hubs fail with no warning as low as 20, 000 miles in 20, 000-lb. axles and 150, 000 miles in 12 and 14, 000-lb. axles. Oil hubs, on the other hand, did give us early signs.

Failing is probably not be the right term as most of us understand that all parts have a predetermine life. What we wanted to figure out was why they were not delivering the life that we expected. In questioning the manufacturers, they told us that the hub has to be service from time to time. But with a unitized hub, I am not sure what servicing means except replacement.

At the recent TMC meeting in Nashville I ask the question about whether shops jack up the front end of the vehicle to lubricate the components (I was really asking about checking front wheel bearings). More than half said they follow the manufacturers’ recommendation, which today is not to jack up the front end. When I asked how they check front wheel bearings then, the crowd was mostly silent, which means most do not know, some do not care, and some just wait for a failure to occur. One fleet said they checked during their annual inspections, which occur at about 120, 000 miles.

You might also like

hub bearing assembly
hub bearing assembly
E46 Rear wheel bearing DIY, final assembly and hub press
E46 Rear wheel bearing DIY, final assembly and hub press

Copyright © . All Rights Reserved